I'm using a ST-LinkV2 clone, for download and debug purposes. Install open folder at: J:AGArcGIS9.3CrackCDInstallInstructionsArcGisv9.3.Cracklicenseservers etup LMSetup.exe 2. Browser version, operating system type and version, wireless network information, device settings, and software data. ![]() In procedure 'init' called at file "embedded:startup.tcl", line 495Īfter a search, I found that I can get the firmware putting the boot0 in VCC, so I did this, and the follow error was shown:Įmbedded:startup.tcl:476: Error: ** Programming Failed ** Info : STLINK v2 JTAG v34 API v2 SWIM v7 VID 0x0483 PID 0x3748Įrror: init mode failed (unable to connect to the target) Download the file fit for your Operating System (Windows XP, Windows Vista, Windows 7, etc.) Once installed, you should. ![]() ![]() I'm studying about STM32 low power modes, and after program the device with _Wfi instruction I cant program another firmware in the device, I tried to use the STM utility to erase the code, but it show that the flash had write protection.
0 Comments
Leave a Reply. |